This is an easier job than you would think. Mark all wires you unplug so you know where they go. Make sure you go all through the dryer and get all parts like the blower fan and housing, vacuum out motor well and clean exhaust. You just unplug the wires from the sensors and remove ductwork that they are attached on and clean the entire thing with soap and water. You need to clean out a drier every two years, at least, according to the manual.
I would get a new belt and change it while you have it apart and get some white lithium grease and grease any bearings you find. You can go to YouTube to see videos on how to take it apart, but do a very good job or it will fail again quickly. You need to totally tear it down and scrape out and wash all of the parts except the motor, which you vacuum out.
The sensor is covered up with lint buildup like concrete and sends a signal to the circuit board chip which means it needs cleaning, and it's not just the lint screen. These driers will do that when the lint builds up like concrete on the inside of the air ducts.
0 kommentar(er)
